PAGE 2 OF 6
0422 IH-9638
LEGS AND FRAME ASSEMBLY
NOTE: Tabletop adds 3/4
"
to height.
1. Flip legs upside down. Place adjustable feet into
legs and slide to desired height. Fasten adjustable
feet to legs with two M10 x 65 hex bolts and two M10
nuts per adjustable foot using a 17 mm wrench.
(See Figure 1)
Figure 1
Adjustable
Feet
M10 x 65
Hex Bolt
M10 Nut
Leg
Leg
2. Turn legs upright and spread apart to
accommodate frame support bars. Position frame
support bars so that the larger holes are facing
down. Line up with legs. Fasten support bars to legs
with four M8 x 65 hex bolts per leg using 13 mm
wrench. (See Figure 2)
Figure 2
Frame Support
Bars
M8 x 65
Hex Bolts
TOP ASSEMBLY
1. To attach tabletop onto frame assembly, place
tabletop on a smooth, non-marring surface with top
side facing down.
2. Rotate assembled frame upside down and line up
with pre-drilled holes in tabletop. Using 20
#28 blunt-end wood screws (22 for H-9639) and drill
with flathead drill bit, attach frame to underside of
tabletop. (See Figure 3)
ONLY USE BLUNT-END WOOD SCREWS
PACKAGED WITH TABLETOP.
NOTE: If holes in frame assembly and
pre-drilled holes in tabletop do not line
up, loosen frame support bars and line up
holes. Insert screws into pre-drilled holes and
re-tighten frame support bars.
3. Carefully set table upright and check all screws
for tightness.
Figure 3
Tabletop
Wood
Screw
Wood
Screw
ASSEMBLY
1-800-295-5510
uline.com
