PAGE 2 OF 6
0823 IH-10657
2. Set dispenser aside and drill into wall at four marked
locations. (See Figure 3)
3. Install provided anchors into drywall and secure
dispenser with provided screws.
INSTALLING BATTERIES
Open the dispenser and locate the battery
compartment on the left side of the dispenser. Place six
AA-cell Alkaline batteries in the proper orientation and
close the cover back into place. (See Figure 4)
INSTALLING CARTRIDGE
1. Place cartridge on top of control box with pump
facing front and downward. (See Figure 5)
2. Pull pump downward and clamp into groove of
control box. Ensure nozzle of the pump is fixed into
the groove of the push rod.
3. Close dispenser cover. The LED indicator will blink
green one time, indicating dispenser is ready
to use.
4. Place hand underneath the dispenser. The LED will
blink green and dispense soap.
WARNING! If the mounting distance is too close
to the basin or other obstacles, the LED will
blink green and red to remind user to remove
obstacles ahead of the sensor or to mount the
dispenser higher.
SETTING THE DISPENSING VOLUME
1. Press the
button to turn the dispenser on/off.
2. Press
to choose the volume of soap to dispense:
= Press once for the standard amount.
= Press again/twice for double the amount.
= Press a third time for triple the amount.
NOTE: If the red LED blinks frequently, the
voltage is low. Press
to turn off. Replace the
batteries and the LED will become normal.
INSTALLATION CONTINUED
Figure 3
Figure 4
Figure 5
1-800-295-5510
uline.com
