PAGE 2 OF 6
0321 IH-6450
INSTALLATION
A
B
B
C
C
D
Figure 1
PREPARATION
1. Turn pegboard around so the front, flush side is
towards the wall. Place pegboard against wall in
desired hanging position.
2. With two people holding the pegboard in place,
mark holes on wall for hanging. (See Figure 1)
3. Pre-drill holes in wall if using anchors.
NOTE: Use a 1/4" drill bit when using the H-4294
Steel Pegboard Mounting Hardware.
4. Remove pegboard from wall. Insert anchors into
holes in wall.
HANGING PEGBOARD
(See Figure 1)
NOTE: Follow this order for best results.
Do not fully tighten screws until all 20
are in place.
1. Turn pegboard around so the front, flush side is
facing away from the wall. Place pegboard against
wall so holes through which screws pass align with
drywall anchors.
2. Fasten 3 top center screws (A).
• 1st row from top, 33rd column from left and 33rd
column from right.
• 1st row from top, 48th column from left.
3. Fasten 4 top outer side screws (B).
• 1st row from top, 1st column from left and
1st column from right.
• 1st row from top, 17th column from left and
17th column from right.
4. Fasten 6 middle outer screws (C).
• 12th row from top, 1st column from left and
1st column from right.
• 24th row from top, 1st column from left and
1st column from right.
• 36th row from top, 1st column from left and
1st column from right.
5. Fasten 7 bottom screws (D).
• 1st row from bottom, 1st column from left and
1st column from right.
• 1st row from bottom, 17th column from left and
17th column from right.
• 1st row from bottom, 33rd column from left and
33rd column from right.
• 1st row from bottom, 48th column from left.
1-800-295-5510
uline.com
