PAGE 4 OF 15
0321 IH-6313
7. Place the bottom (6) in lowest notch of shelf
adjusting strips so that the flange with two holes
faces the front and is over the flange of the frame
sill. Push out on side wall to enable bottom to slide
into position. (See Figure 5)
8. Bolt bottom to frame sill.
9. Using a rubber mallet, place adjustable shelves in
desired position with channeled edge toward front
and press end and back flanges into notches of
shelf adjusting strips.
10. Set the unit upright and insert the remaining shelves
as desired. (See Figure 6)
11. Tighten all hardware.
ASSEMBLY CONTINUED
6
Figure 5
Figure 6
ELECTRONIC LOCK INSTRUCTIONS
1
4
7
*
0
#
3
6
9
2
5
8
OPEN
01:52
11 11
11
11
11
11
11
Override Key
Cover Plate
Handle
Keypad
Main Display
Date and Time
Display
Battery
Compartment
Reset
Button
GETTING STARTED
1. The battery compartment is located on the back of
the electronic lock. To insert batteries, lift up on the
compression tab at the bottom of the compartment.
NOTE: The key for manual entry is located
within the battery compartment. Keep this key
in case of battery failure.
ENTERING SECURITY CODE
1. There are two preset codes, a personal and an
administrator. The factory presets are:
Personal (Pass 1): 1 2 3 4
Administrator (Pass 2): 1 2 3 4 5 6
2. Press # key. Display will read "
––––––––
."
3. Enter the code and press the # key. Once
confirmed, display will read
OPEN
.
FRONT
BACK
