PAGE 3 OF 12
0421 IH-5553
NOTE: Do not tighten bolts until unit is
completely assembled.
1. Place back panel (1) on a protected flat surface so
that the flanges face upward. (See Figure 1)
2. Bolt side panels (2) to back panels (1), making sure
side panel fits within the flange of the back panels.
The side panels should not go between two back
panel flanges. (See Figure 2) The ends of the back
and side panels with the two large holes are at the
bottom of the locker.
NOTE: Do not put nuts and bolts in bottom
three holes on outside corners of locker, as
those will be used later to attach legs.
NOTE: Bolts will be shared between panels that
are next to each other.
3. Install tops and bottoms (3) to side panels and back
panels. Only bolt through the middle hole when
attaching to back panel. Bolt shelves (4) to side
and back panels, spaced evenly apart.
(See Figure 3)
ASSEMBLY
1
Figure 1
1
1
2
Top View
1
1
2
2
2
2
Figure 2
4
3
3
Figure 3
