PAGE 3 OF 4
0214 IH-4406
4b. Using other end of assembled X-brace from the
right frame, attach to the bottom hole and third
hole up from the bottom on the middle frame.
With the second assembled X-brace, attach to
the middle frame using the same bottom hole
and third hole up from the bottom (the brace ends
overlap). Only one notched end may be on the
bottom hole and one on the third hole up from the
bottom. Hand tighten. (See Figure 9)
4c. Attach assembled X-brace to the left frame using
the other end of assembled X-brace. Hand tighten.
NOTE: Not all holes on the frame will be used.
4.
5. At this point frame is able to stand up on its own.
Make sure the frame is straight, square and level.
Tighten all 3/8"
bolt connections with socket wrench.
(See Figure 10)
6. On the frame, place a clip on each hole of the
seat and foot braces. On the foot braces, use the
intermediate holes. The clips should have the center
indent facing up and be horizontal. Insert 5/16"
carriage bolt through each clip and frame and
attach nut loosely. (See Figures 11 and 12)
ASSEMBLY INSTRUCTIONS CONTINUED
Figure 10
Intermediate
Holes
Figure 12
Figure 11
Figure 9
Figure 7
Figure 8
