
PAGE 2 OF 3
0812 IH-3533
OPERATION CONTINUEd
TO EmPTY ThE mAgAzINE
1. Pull the pusher all the way back until it snaps in
around the parking button. (See Figure 3)
2. Take the staples out and release the pusher by
pressing the parking button. (See Figure 4)
REmOVINg STUCK STAPlES
1. Park the staple pusher in its rear position. Just loosen
the 2 screws (a) holding the front plate and move
the plate downward to remove. Remove any staple
remnants. Remount the parts in the reverse order
and release the pusher. (See Figures 5 and 6)
Figure 5
a
a
Figure 6
SAfETY WARNINgS
NOTE: Read these warnings to prevent injuries
to yourself and those around you.
• Never use oxygen, combustible gases, CO
2
, steam
or high pressure gas tanks as power sources. The
stapler may explode and cause serious injury.
• Use only dry, clean pressure-regulated compressed
air to drive the stapler.
• Eye protection must be worn by the operator and
others in the work area.
• Always use personal protection equipment as
required, such as ear protection, hard hats, etc.
• Never use a defective stapler. Ensure the trigger
operates properly and all screws and nuts are
secured tightly at all times.
• Do not modify the stapler.
• Always disconnect the stapler from the air supply
and empty the magazine when taking a break
or ending work, when servicing the stapler or
eliminating malfunctions.
• Never leave a loaded stapler unattended.
• Always assume that the stapler is loaded. No
horseplay! Respect the stapler as a working
implement.
Figure 3
Figure 4