PAGE 2 OF 18
0517 IH-2526
ASSEMBLY
GETTING STARTED
1. Make sure the power switch is in the OFF position
(down). (See Figure 1)
2. Insert the AC power cord into the power supply.
(See Figure 1)
3. Plug the other end of the cord into an appropriate
AC electrical outlet.
Note: The active power light will go on if power
is on at the AC outlet. (See Figure 1)
4. Insert the power supply's power connector into the
printer's power receptacle. (See Figure 1)
Power Receptacle
Printer
Power Switch
Power Connector
Plug (Varies by Country)
AC Power Cord
IEC 60320 C-13
Power Supply
Active Power Light
Figure 1
LOADING THE PRINTER
1. Open the printer. Pull the release latch levers toward
the front of the printer. (See Figure 2)
2. Open the media roll holders. Pull the media guides
open with your free hand and place the media roll
on the roll holders and release the guides.
(See Figure 2)
3. Orient the media roll so that its printing surface will
face up as it passes over the platen roller.
(See Figure 2)
Media Roll Holders
Release Latch Levers
Platen Roller
Figure 2
Media Roll