PAGE 2 OF 9
0721 IH-2272
MOUNTING
NOTE: Recommended mounting height is 52"
from the floor to the bottom of the dispenser.
If using template, recommended mounting
height is 52" from floor to bottom edge shown
on template. (See Figure 8)
NOTE: Ensure that proper mounting hardware
is used for appropriate wall composition as
enclosed hardware may not be compatible
with your wall surface.
1. Insert the key into the lock opening on the top of
dispenser and push until cover pops open. If push
button is installed, gently push the button until the
cover opens. (See Figure 6)
2. Tape mounting template to wall at desired height
and ensure that template is level. (See Figure 7)
3. Pre-drill mounting holes if necessary and remove
template. Insert wall anchors if necessary. (See Figure 8)
4. Position dispenser over holes or markings on wall and
insert screws through holes in dispenser and tighten.
(See Figure 9)
Figure 6
Figure 8
Figure 7
Recommended
Mounting
Locations
Figure 9
DECORATOR STRIP INSTALLATION
1. Open cover to expose inside of decorator strip
window.
2. Slide decorator strip into place, making sure the
decorator strip is held by the plastic guides.
(See Figure 5)
3. Close cover firmly and lock.
Figure 5
Decorator Strip
Decorator Strip
Window
