PAGE 3 OF 9
0224 IH-11087
ASSEMBLY CONTINUED
CHAIR ADJUSTMENTS
1. Seat Height Adjustment – To raise seat height, lift
lever up with little to no weight on the seat. To lower
seat height, lift lever up while sitting.
2. Upright Tilt Lock – To lock chair in an upright position,
push the lever down. To restore tilt, pull the lever up.
Chair has synchronized knee tilt; the pivot point is
located near the front edge of the chair.
3. Tilt Tension – To increase tilt tension, turn knob
clockwise. To decrease tilt tension, turn knob
counterclockwise.
4. Adjustable Lumbar Support – To increase lumbar
support, turn knob clockwise. To decrease lumbar
support, turn knob counterclockwise.
5. Back Recline – To recline backrest, pull up on lever
to engage. Release lever to lock in recline.
6. Armrest Adjustment
A. Height – Pull lever under outside of armrest pad
and move the armrest up or down.
B. Width – Push button under inside of armrest pad
and move the armrest in or out.
C. Depth – Push button on inside front of armrest
pad to move the armrest front or back.
D. Pivot – Push button on inside front of armrest to
pivot the armrest in or out.
6. Attach seat side covers over backrest brackets using
two M5 x 10 mm bolts. Place caps over bolt holes
once tightened. Repeat for opposite side.
(See Figure 6)
NOTE: Inside of seat side covers are marked
"L" for left side and "R" for right side installation.
Figure 6
M5 x 10 mm Bolt
Cap
1
4
5
6A
6B
6C, 6D
2
3
1-800-295-5510
uline.com
