PAGE 12 OF 13
0922 IH-10066
TROUBLESHOOTING
OPERATING ISSUE
CAUSES
RECOMMENDATIONS
Battery display remains
dark.
Battery faulty/fully discharged.
Inserted battery not permitted
(wrong battery).
Battery not properly inserted.
Charge/replace battery.
Insert correct battery.
Check whether battery is completely
inserted and unlocking device engaged.
User interface and tool
status indicator do
not react.
Sleep mode is activated.
Actuate trigger.
Tool status indicator
red and pulsating
(stapler blocked).
Process sequence warning.
Actuate trigger.
Remove jammed staples; see page 10.
Tool status indicator
pulsating quickly.
Staple encounters obstacle.
Clamp does not go through carton
(too hard).
Ensure that there are no obstacles.
Only staple common corrugated material.
No stapling performed
when actuating trigger.
Box detection not activated (tool
not on carton).
Place tool on carton.
Skipping staples or
intermittent feed.
Magazine not mounted correctly.
Staples out of specification.
Magazine quick release buttons
not locked.
Magazine dirty/debris inside.
Driver blade/clinchers dirty/debris
inside.
Install magazine; see page 10.
Replace with recommended staples.
Lock magazine quick release buttons.
Clean magazine.
Clean/replace driver blade and/or clinchers;
see page 11.
Staple jammed in tool.
Wrong staple size.
Bent staples.
Staples out of specification.
Defective/dirty driver blade.
Replace with recommended staples.
Clean/replace driver blade and/or
clinchers; see page 11.
Slow stapling speed or
blocked.
Battery fully discharged.
Carton too thick.
Charge/replace battery.
Use other carton thickness.
Poor staple clinch.
Wrong leg length setting.
Wrong penetration setting.
Wrong clinch setting.
Driver blade/clinchers dirty/
debris inside.
Adjust staple length; see page 9.
Adjust penetration depth; see page 9.
Adjust staple clinch; see page 9.
Clean/replace driver blade and/or clinchers;
see page 11.
