PAGE 2 OF 9
0522 IH-10033
ASSEMBLY CONTINUED
2. Attach keyboard tray to mount using four M5 x 12 mm
bolts. Tighten using Phillips screwdriver. Insert four
caps to cover bolts. (See Figure 2)
Figure 2
Keyboard Tray
M5 x 12 mm Bolt
Cap
3. With a second person, align keyboard tray in
desired position. Attach unit underneath the desktop
using a drill and four wood screws. (See Figure 3)
NOTE: It is recommended to position the unit
so the front edge of the keyboard tray is flush
with front edge of desktop when fully retracted.
Keyboard tray needs to be extended to attach.
NOTE: If desired, pilot holes can be created
using a drill and a 4 mm drill bit. The pilot holes
should go no deeper than 9/16".
Figure 3
Desktop
Flush
Wood Screw
WITH BRACKETS
1. With both brackets angled outward, attach brackets
to track with four M5 x 8 mm bolts. Tighten using
Phillips screwdriver. (See Figure 4)
NOTE: Bracket orientation below is compatible
with most desks. If necessary, brackets can be
angled inward.
Figure 4
Bracket
Track
M5 x 8 mm Bolt
2. Attach the mount to the track using four
M5 x 8 mm bolts. Tighten using Phillips screwdriver.
(See Figure 5)
Figure 5
Mount
Track
M5 x 8 mm Bolt
