5.
On a clean surface, place the wood panel face down and tape the
existing drawer panel (removed in step 3) on the back of the wood
panel (Figure 4) and drill the five (5) holes (5/32" drill 3/8" deep)
through the drawer panel and 3/8" into the wood panel (Figure
1). Remove tape from the drawer panel, and enlarge the five
holes in the front panel using a .201" drill (#7) drill.
6.
Attach the drawer panel to the wood panel using #10 x 5/8"
(P/N 42121) wood screws and nylon spacers (P/N 42120).
The nylon spacers fit between the wood panel and the drawer
panel as shown (Figure 5).
Drawer panel and wood panel must be aligned properly or
drawer will not operate correctly.
Assembling the drawer and wood panel:
7.
Install the overlay panel by sliding the drawer panel back into the
drawer frame.
8.
Replace the handle assembly and secure with the two screws
removed in Step 2.
9.
Starting at the corners and working toward the center, push
the drawer gasket back into place.
TYPICAL
WOOD
PANEL
PLASTIC SPACER
FIVE REQUIRED
#10 X 5/8" ROUND
HEAD SCREW
FIVE REQUIRED
DRAWER PANEL
DWR_OL_005
Figure 5
