www.U-LineService.com
10
02/2005
™
2075DWRWC — Drawer Model Wine Captain
®
Top-to-Bottom (and Left-to-Right)
Adjustment
See
Figure 14
. The drawer will need a Top-to-Bottom
Adjustment if, when viewed from the front, the drawer is
not level horizontally. Viewed from the top, one side will
protrude. This is caused by one of the slides being
mounted higher than the other slide on the unit’s liner.
Minor Adjustment:
Note:
The mounting holes
on the slide are slightly
larger than the screws’
diameter.
1. Loosen one slide’s
mounting screws.
2. Push the slide upward
or downward to match
the position of the
other slide.
3. Retighten the screws.
See
Figure 15
.
4. Repeat the procedure
with the other slide if
necessary.
Severe Adjustment:
Note:
The slides have
extra mounting holes that
may be used.
1. Remove one slide’s
mounting screws.
2. Reposition the slide so
it is the same distance
from the bottom of the
liner as the other slide.
Measure to confirm.
3. Mark new drilling holes
using different sets of
mounting holes on the slide. See
Figure 16
.
Note:
Front location holes are shown. Corresponding rear
holes will also need to be marked.
4. Drill all the new holes with a #30 drill bit.
5. Remount the slide.
Re-installation of Drawer
CAUTION
Use care when handling the drawer. Drawer edges,
drawer rail and the unit’s slide may be sharp.
1. Set the drawer’s rails onto the slides.
2. Re-install the rails’ mounting screws. See
Figure 7
on
Page 8
.
3. Plug in the drawer’s connection wiring (top drawer
only).
4. Go on to
6 Prepare Power Supply
.
Front View of Unit
Not Aligned Top-to-Bottom
Top View of Unit
Not Aligned Left-to-Right
Figure 14
Loosen
Mounting Screws
Push Slide
Upward or
Downward
Figure 15
Mark and Drill New
Mounting Holes
Push Slide
Upward or
Downward
Figure 16
