NORA-W2 series - Hardware integration manual
UBX-22005177 - R01
Regulatory compliance
Page 40 of 61
C1
–
Public
Le produit hôte devra être correctement étiqueté, de façon à permettre l’identification des modules
qui s’y trouvent.
L’étiquette d’homologation d’un module d’Innovation, Sciences et Développement économique
Canada devra être posée sur le produit h
ôte à un endroit bien en vue, en tout temps. En l’absence
d’étiquette, le produit hôte doit porter une 25ecessair sur laquelle figure le numéro d’homologation du
module d’Innovation, Sciences et Développement économique Canada, précédé du mot « contient »,
ou d’une formulation similaire allant dans le même sens et qui va comme suit:
This device contains
FCC ID: XPYNORAW1W2
IC: 8595A-NORAW1W2
Figure 14: Example of an end product label
6.4.6.2
FCC Compliance
For an end product that uses the NORA-W2 modules, there must be a label containing, at least, the
information shown in
The label must be affixed on an exterior surface of the end product such that it will be visible upon
inspection in compliance with the modular approval guidelines developed by the FCC.
☞
In accordance with 47 CFR § 15.19, the end product shall bear the following statement in a
conspicuous location on the device:
"This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions;
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation."
The label must be affixed on an exterior surface of the end product such that it will be visible upon
inspection in compliance with the modular approval guidelines developed by the FCC.
When the device is so small or for such use that it is not practicable to place the statement above on
it, the information shall be placed in a prominent location in the instruction manual or pamphlet
supplied to the user or, alternatively, shall be placed on the container in which the device is marketed.
In case, where the final product will be installed in locations where the end-user is not able to see the
FCC ID and/or this statement, the FCC ID and the statement shall also be included in the end-product
manual.
6.4.7
End-product compliance
6.4.7.1
General requirements
•
Any changes to hardware, hosts or co-location configuration may require new radiated emission
and SAR evaluation and/or testing.
•
The regulatory compliance of the NORA-W2 modules does not exempt
•
Only authorized antenna(s) may be used.
•
Any notification to the end user about how to install or remove the integrated radio module is NOT
allowed.
•
The approval of the modular transmitter in NORA-W2 series modules does not exempt the end
product from being evaluated against any applicable regulatory demands. The evaluation of the
end product shall be performed with the NORA-W2 module installed and operating in a way that
reflects the intended use case of the end product. The upper frequency measurement range for
the end product evaluation is the 5th harmonic of 2.4 GHz as declared in 47 CFR Part 15.33 (b)(1).
