ANT-B10 - User guide
UBX-22006906 -
R02
Software and flashing
Page 17 of 29
C1-Public
5
Software and flashing
This chapter describes how the ANT-B10 board is flashed with u-connectLocate software. The
software is flashed using s-center or flashed directly on the command line.
5.1
Flashing using s-center
ANT-B10 can be flashed over the UART using s-center
☞
This requires s-center 6.1 or later.
Follow the procedure outlined below to flash ing when using s-center:
1.
Download and unzip the u-connectLocate software container as described in
2.
Open s-center on the correct COM port once the module is in software download mode.
3.
Select
Software Update
.
4.
In the “Software Update” dialog
select the binary file in the software container, as shown in
. Make sure the flashing speed is set to 115200.
5.
Press
Update
.
Figure 11: Updating the software on the board using s-center
