special mode OFF that can’t ring. (If you don’t want to use the alarm clock after setting, please choose
OFF mode ,it won’t ring)
⑻
Press previous or next button to change the mode of ring tones. Now the screen flashes, the flash
time is five seconds.
⑼
Short press M to confirm the setting.
⑽
It will go to alarm clock 2 setting after finished alarm clock 1,the setting method is same as alarm
clock 1. If you didn’t finish the setting and press M ,it will be unworkable alarm clock setting.
3.Ringing alarm setting
⑴
It will ring when clock and alarm clock time is same, meanwhile the background light will be on, the
volume will increase gradually, it will be the loudest sound after one minute, it will ring continuously for
one hour if no stop.
⑵
Press any button to stop the ringing.
Tzumi Clock Technical Parameters
Output: 6W 3W*2
Frequency:20-18000HZ
（
+/-3dB)
S/N:
≥
80dB
Speaker:45mm Speaker Impedance:4
Ω
Input:DC 5V
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
(1)this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
