TYROLIT Hydrostress HBE 350, Operating Instructions Manual, Page: 9 / 24

ELECTRICAL CONNECTION
The network voltage must conform to the voltage indicated on the tool name plate. Under no
circumstances should the tool be used when the power supply cable is damaged. A damaged cable
must be replaced immediately by an authorized Customer Service Center. Do not try to repair the
damaged cable yourself. The use of damaged power cables can lead to an electric shock.
WARNING: Never operate a damaged machine. Always tag
a damaged machine and take it out of service until repairs
can be made.
WARNING: These machines are equipped with a Portable
Residual Current Device (PRCD) also known as a Ground Fault
Circuit Interrupter (GFCI). Always use this device whenever
using the machine to reduce the risk of shock hazards.
Always position the PRCD as close as possible to the power
source. Test and reset the PRCD device before each use. Press
the “Test” button to test. Press the “Reset” button to energize
the circuit to the machine.
Cover
Test Button Reset Button On Lamp
Note:
PRCD (GFCI) appearances vary
according to the requirements of
various regions. Photos for reference
only
WARNING: Always connect the plug into the wall socket with a drip loop. If the cable leads downward
directly into the wall socket, any water on the cable could run into the socket, causing a hazard.
INTRODUCTION
This machine is equipped with two handles and a blade guard. The motor has overload and overheat
protection. It has an integrated water feed system as required for diamond cutting and has a portable residual
current device (PRCD) for electrical safety. It must only be used with a diamond blade. It is intended for cutting
masonry, stone, concrete, reinforced concrete and similar materials. All other uses are prohibited.
LIST OF CONTENTS
• Concrete Saw
• Guide Roller Assembly
• M17 Combination Wrench
• Splash Guard
ASSEMBLY
• Mount the blade. ( See below “Mounting the Blade”)
• Mount the Guide Roller Assembly if desired ( See below “Guide Roller Assembly”)
• Mount the blade guard brush (See below "Blade Guard Brush" for assembly instructions)
• Mount the splash guard (See below "Splash Guard" for assembly instructions)
9