TypeS PROJUMP 14000S, Manual

Page: 24 / 32

EN
22
3. Connect the RED clamp to the POSITIVE (+) post on the
car battery. The POSITIVE battery post will be slightly larger than the NEGATIVE post, and will
be marked with a PLUS (+) sign. There may also be a RED plastic protective cover over the
positive battery post.
4. Connect the BLACK clamp to the NEGATIVE (-) post on the car battery. The NEGATIVE will
be marked with a MINUS (-) sign. There may be a BLACK plastic protective cover over the
negative battery post.
NOTE: Do not connect the RED clamp (+) and the BLACK clamp (-) at the same time. Connect
the RED clamp first, then the BLACK clamp.
CAUTION:
DO NOT lean directly over the battery while making jumper connections.
5. Check the LED status on the Polarity Circuit Protection Box. Proceed to the next step unless the LED is flashing RED
and BEEPING. Reference Polarity Protection Circuit Status chart in the next section.
6. Once the clamps are properly connected to the vehicle battery, the LCD Display will read:
Ready for jump start Start engine now . You have 90 seconds to start your vehicle before
the PROJUMP shuts off in order to prevent the vehicle battery from reverse charging the
unit.
NOTE: If vehicle does not crank, or cranks very slowly, wiggle the cable clamps on the vehicle battery to ensure they
are making good contact. Wait 60 seconds before trying to jump start your vehicle again. Each new jump start attempt
requires disconnection of both clamps from the vehicle battery and reconnection.
The engine should start if there are no other problems (such as a bad starter or ignition circuit problem). Do not attempt
to jump start the vehicle more than 3 times with the PROJUMP. If the vehicle fails to start after 3 attempts, it is likely due
to alternative reasons that should be checked by an auto mechanic.
7. When the engine starts, the LED on the Polarity Circuit Protection Box will blink RED and
beep. The LCD Display will also read: Successful Jump Unplug cables Check car battery
8. Disconnect the cables from your vehicle within 30 seconds. First remove the BLACK /NEGATIVE (-) clamp and then the
RED /POSITIVE (+) clamp.
80%
Ready for jump start
Start engine now
80%
Successful Jump
Unplug cables
Check car battery