Tynetec ZXT475, Manual

Page: 1 / 4

Doc No. FM0599 issue C Page 1
169MHz Telecare Devices
PIR Movement Detector
__________________________________________________________________________________________________________

Passive infrared detector

Walk test LED (disabled during normal operation)

Alarm interval: 1 or 3 minutes

User replaceable AA Lithium batteries

Low battery warning

Dimensions: 121mm x 71mm x 55mm (HxWxD)

Weight: 135 grams

Tynetec Part No. ZXT475
What can the PIR Movement Detector be used for?
The PIR detector can be used for 2 different applications;
Intruder Monitoring – if movement is detected an alarm is reported
Inactivity Monitoring – if no movement is detected within a preset period an alarm is reported
Recommended Location
The PIR should be wall mounted at high level (2.1m) in the hallway to monitor movement between rooms.
If there are pets in the home the PIR should be inverted and fitted at low level (1m) – see PET ALLEY mode.
To avoid false alarms there should be no moving objects or rapid temperature changes (heating ducts) in the detection area.
Typical Tools Required
Be careful when using step ladders – always face the direction you are working.
A drill is not required if the self adhesive fixing pad is used.
Always make sure the correct drill bits and screwdrivers are used.
Installation – Using Screw Fixings
1. Undo SCREW “ A ” from the bottom of the detector and remove the UP
complete lid assembly.
2. Drill ‐ out the 2 most suitable FIXING HOLES “ B ” inside the rear section.
Use this as a template to mark the wall.
3. Before drilling the wall be sure there are no electrical cables NORMAL
or plumbing under the surface. ORIENTATION
4. Use the screws & plugs provided to fix the rear section to the wall SCREW “ A ”
noting the correct orientation (see next page for PET ALLEY).
5. Remove the insulating tab to connect the batteries,
refit the lid and tighten the screw. FIXING HOLES “B” B
Installation – Using Self Adhesive Pads
B B
Undo SCREW “ A ” and remove the lid assembly.
Remove the insulating tab to connect the batteries. B B
Refit the lid and tighten the screw.
Select the best location where the wall surface is clean, dry and even.
Stick the adhesive pad to the rear of the detector.
Press the detector firmly against the wall ensuring it is stuck securely.
Tynetec, a business unit of Legrand Electric Ltd
Unit 10 Cowley Road, Blyth Riverside Business Park, Blyth
Northumberland, NE24 5TF. Tel: 01670 352 371 Fax: 01670 362 807
Email: sales@tynetec.co.uk Web : www.tynetec.co.uk