Doc No. FM0576 issue G Page 3
Registering a No Alarm Door Contact onto an
Advent xt
warden call system
1. Put the Advent xt system into radio device lea
rn mode…
2. Activate the door contact…
3.
Exit the Advent xt system radio device learn mode…
4. Activate the door contact; Logon to Tynetec
’s iCare website and check the event has been recorded.
Note: the iCare website
collects data at pre-set intervals (e.g. every 2 hours) on Advent xt.
Deleting a No Alarm Door Contact from an
Advent xt
warden call system
Press the
LINE
key and wait for the
“
Ready
” prompt.
Enter
5 0 0 1
followed by the
key.
Enter the flat number the no alarm door contact is being deleted from followed by the
key.
Activate the door contact to be deleted.
W
ait for the “
Pendant Disabled
–
Enter Flat
” prompt.
Press the
#
key
and wait for the “
Ready
” prompt
, then press the
LINE
key to clear the connection.
Refer to the Advent xt
operator’s
manual (Doc No. FM0420) provided with the warden call system for more
information on programming and testing radio devices.
Tynetec and Aidcall operate a policy of continuous improvement and reserve the right to change product specifications without notice.
If any variation to the details contained in this document are suspected please contact Tyn
etec’s customer support dept on 01
670 352371.
Usin
g the Manager’s DECT telephone;
Press the
LINE
key and wait for the “
Ready
” prompt.
Enter
5 0 0 0
followed by the
key.
Enter the flat number the no alarm door contact is being installed in
followed by the
key.
You now have 1 minute to activate the door contact.
“
Ready”
Using the Manager’s DECT telephone;
Press the
#
key and wait for th
e “
Ready
” prompt.
Press the
LINE
key to clear the connection and the warden call system is
now back in normal operating mode.
Open the door.
W
ait for the “
Enter Location Code
” prompt
then press
0
(no location)
followed by the
key.
W
ait for the “
Pendant Enabled
–
Enter Flat
” prompt.
“
Ready”