TYM T353, Operator'S Manual

Page: 41 / 92

► ► ► ►
HYDRAULIC REMOTE CONTROL VALVE LEVER
The Hydraulic Remote Control Valve Lever is located on
the RHS of Operator.
Move the lever up or down and hold.This will raise or
lower the implement (Rotavator or Hydraulic plow).
Important:
-Do not hold the lever in the “pull” or “Push” position once
the remote cylinder has reached the end of the stroke as this
will cause oil to flow through the relief valve. Forcing oil
through the relief valve for extended periods will overheat the oil.
-When Using the tractor hydraulic system to power front loader,
Always set the knob to lock when
1.Traveling on the road
2.Replacing tires or blades on an implement.
3.Making adjustments to an implement. Sudden dropping of an implement due to
hydraulic problems can cause serious injury or death.
Caution
do not operate the boom and bucket cylinders simultaneously.
► ► ► ►
HYDRAULIC REMOTE CONTROL VALVE COUPLER CONNECTING & DISCONNECTING.
■ Connecting
1.Clean both couplers.
2.Remove dust plugs.
3.Insert the implement coupler to the tractor hydraulic coupler
4.Pull the implement coupler slightly to make sure couplers are
firmly connected.
■ Disconnecting
1.Lower the implement first to the ground to release
hydraulic pressure in the hoses.
2.Clean the couplers
3.Relieve pressure by moving hydraulic control levers
with engine shut off.Pull the hose straight
from the hydraulic coupler to release it
4.Clean oil and dust from the coupler,then replace the dust plugs.