2/4
Starting on the driver side of the vehicle, locate the (5) pairs of
factory holes along the bottom of the body, (pinch weld). NOTE:
Side Armor will attach to the 2nd, 3rd and 5th mounting
locations, (Figure 1). Directly above each pair of holes, locate
the factory mounting holes in the inner side panel, (Figures 1,
3-5). NOTE: The inner holes may be covered with sealing tape or
insulation.
STEP 1
(Fig 1) Driver/left body mounting locations
along back of inner rocker panel illustrated
Front
(Fig 2) Locate the factory holes along the pinch
weld. Start at the 2nd pair of factory holes
(Fig 3) Typical Mounting Location
Factory holes
in pinch weld
Line up Clip Nut
with factory hole
Fig 4
Factory holes in pinch
weld pictured from
behind body panel
Line up Clip Nuts
with factory holes
Front
(Fig 5) Driver/left center mounting location
1-866-340-3038
www.tygerauto.com
