2
Qwik Install
STEP 1:
Connect included solar panel cable to the solar panel inside
wire junction box or to the solar panel MC
-
4 connectors (if applicable).
Install solar panel to the mount so that junction box is at the top or side.
Install mount to
2”
to
4”
pole. Solar panel should be facing South if in
Northern Hemisphere. If you are planning to keep solar panel angle
fixed all year then set the angle to Your_Latitude * 0.9 +30
STEP 2:
Mount any electronics inside the enclosure then mount the
enclosure to the pole. We recommend mounting the enclosure directly
under the solar panel and just low enough that the enclosure cover can
be opened without interfering with solar panel tilted at its winter angle.
Note:
The enclosure and solar panel can also be mounted to a wall if
desired.
STEP 3:
Install batteries to enclosure using Velcro straps.
If the Solar Panel is 12V output (18V typ) you must wire the
batteries in a 12V configuration. If the solar panel is a 24V
output (28V Typ), you must wire the batteries in a 24V config-
uration.
STEP 4:
Connect the Battery cables to Controller battery terminals
(Batt+, Batt
-
) and then to the batteries. Be sure to observe proper polar-
ity. Black wire connects to battery negative terminal and Battery(
-
) ter-
minal on the controller. When a fully charged battery is connected, the
