3. Programming
D-306488 WK250 Installer’s Guide
63
Option
Instructions
While in the panic button test process, indicated by the corresponding display, for
example, "
TEST PANIC BT: XX
", press a button on the pendant.
TEST ONE DEVICE
You can select a specific device group you wish to test, for example, Motion
Sensors.
Press
to enter the "
TEST ONE DEVICE
" sub menu and use
to scroll
through the device families. Press
to enter the
<device family>
sub menu,
for example: "
MOTION SENSORS
".
The following screen will appear:
"
Xxx:<device name>
"
"<
location
>"
Where Xxx indicates the device number.
If there is no device, the following screen will appear: "
NO EXISTING DEV.
".
Press
to test the selected device. The following screen will appear:
"
TESTING Zxx NNN
".
While in the handheld devices test process, indicated by the corresponding display,
for example, "
TEST KEYFOBS 01
", press any key of the selected handheld device
to initiate the test.
At the end of the test process, the WK250 will present the devices' status:
"
Zxx: 24hr: <status>
"
"
Zxx: NOW: <status>
"
1
.
Note:
Refer to "
SHOW ALL DEVICES
" section for further information on device
status.
CONTACT SENSORS
MOTION SENSORS
GLASSBREAK SENS.
SHOW ALL DEVICES
You can view the devices status.
Note:
This option is available only after testing process was done.
Press
to view the devices' status.
The following screen will appear:
"
Zxx: 24hr: <status>
"
1
"
Zxx: NOW: <status>
"
1
Use
to scroll between the device's families.
1
The signal strength indications are as follows: "
STRONG
";
GOOD
"; "
POOR
"; "
1-WAY
" (the device operates in 1-way
mode or, the "
NOW
" communication test failed); "
NOT TST
" (results are shown without any performed test); "
NOT
NET
" [device is not networked (not fully enrolled)]; "
NONE
" (keyfob 24Hr result); or "
EARLY
" (result of the last 24Hrs
without statistics).