MDE142E0
36/60
06/04/04
10. VIEW ROUTINES
10.1. Actuator set-up routines
The above menu allows viewing the present actuator configuration. No change can be made at the present data. The
following data can be viewed:
ROUTINE
PARAMETERS
Ø
STROKE LIMITS
Ø
close direction,
Ø
POSITIONER
Ø
dead band; control band OP,K,K2/CL,K,K2; polarity; position % OP/CL
Ø
ESD CONTROL
Ø
ESD action, signal type, ESD priority
Ø
LOCAL CONTROLS
Ø
manual speed OP/CL, LED’s colour
Ø
OUTPUT RELAYS
Ø
default #; monitor relay conditions; ASi conditions, contact action
Ø
FAIL SAFE
Ø
actuator action in case of failure (off; % CH; % OP; STAY-PUT); delay
Ø
OUTPUT 4-20 mA
Ø
valve position with 4 mA (4 mA=CL/OP)
Ø
INTERLOCK
Ø
signal type (CL/OP); absent/present)
Ø
MISCELLANEOUS
Ø
time and date; Pump (mode) valve jammed time
View procedure:
•
Move the local selector to OFF and then press simultaneously OPEN and STOP. Select the language according to
the instructions “entering the view mode”. When the message of display is “VIEW MODE OK?” press YES. Press
YES to select
actuator set-up
menu.
•
Press NO to scroll the list of available routines and press YES to select.
•
Press YES to answer at the prompt “view” or “next” and to see the data
10.2. Name plate routines
To identify the actuator, this menu can view many data. The data are entered at the time of the actuator manufacture
and can be changed only by the manufacturer. The following data may be viewed:
ROUTINE
PARAMETERS
•
serial number
•
actuator type
•
nominal torque/thrust
•
power supply)
•
motor data
•
test date
•
operating/wiring diagram
•
oil type
•
HW / SW version
•
(max. 28 char.)
•
(max. 28 char.)
•
Nm/kN
•
V ac/dc; frequency (Hz)
•
Power; V ac; frequency (Hz)
•
day/month/year
•
(max. 28 char.)
•
type and maker
•
HW release; SW release .
View procedure:
•
Move the local selector to OFF and then press simultaneously OPEN and STOP. Select the language according to
the instructions “entering the view mode”. When the message of display is “VIEW MODE OK?” press YES. Press
NO to scroll the list of available menus and press YES to select
nameplate
menu.
•
Press YES to answer at the prompt “view” or “next” and see the data of the above list.
10.3. Valve data routines
To identify the valve and its function in the process the following data can be viewed.
Ø
tag name (max. 28 char.)
Ø
serial number (max. 28 char.)
The data should be entered by the valve manufacturer or by the end user during set-up operations.
View procedure:
•
Move the local selector to OFF and then press simultaneously OPEN and STOP. Select the language according to
the instructions “entering the view mode”. When the message of display is “VIEW MODE OK?” press YES. Press
NO to scroll the list of available menus and press YES to select
valve data
menu.
•
Press YES to answer at the prompt “view” or “next” and see the data of the above list.
