Instruction Sheet
SDE- SA Commercial Hand Tool for
408--10309
LOC B
1
of 4
E
2010 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
TOOLING ASSISTANCE CENTER 1--800--722--1111
PRODUCT INFORMATION 1--800--522--6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
www.tycoelectronics.com
26 JAN 10 Rev D
UTILUX* Connectors
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended--use, production operations is available.
Handle
Emergency
Ratchet
Release
Die Retaining
Screws
Ratchet Adjustment
Wheel
Moving
Jaw
Die Sets
2063195--2,
1976147--2
Stationary
Jaw
Anvil (Lower)
Wire Die
Wire Crimper
(Upper Die)
Insulation Crimper
(Upper Die)
Anvil (Lower)
Insulation Die
Pins (4)
Locator
Locking Nut
TE Crimp Tooling
UTILUX
Cable
Wire Insulation
SDE--SA
Tool
Die
Assembly
UTILUX
Connector
Qty
Cable Type
mm [Inch]
Conductor
Size
Dia
mm [Inch]
Strip Length
mm [Inch}
2063765--1
2063765--2
1--659268--0
1
Olex Railway
Cable
{
2008--01--12(L)
.75mm
2
[18]
Doubled Over
3.5mm [.138]
10.0mm [.39]
Conductor
Doubled Over
1976147--1
1976147--2
1 659268 0
2
Advance Railway
Cable
}
.75mm
2
[18]
2.4mm [.094]
5.0mm [.197]
Figure 1
1. INTRODUCTION
SDE--SA Commercial Hand Tool Assemblies for the
UTILUX connectors consist of the tools and die sets
shown in Figure 1. The tools consist of the of
SDE--SA Frame Assembly 9--1478240--0 (Instruction
Sheet 408--8851) and die assemblies listed in
Figure 1. The tool is used to crimp the terminal
number provided in the table in Figure 1.
Dimensions in this instruction sheet are in
millimeters with [inches in brackets]. Figures and
illustrations are for reference only and are not
drawn to scale.
Reasons for revison are provided in Section 9,
REVISION SUMMARY.
Read these instructions thoroughly before crimping
connectors.
}
Advance Wire and Cable Pty Ltd
{
Olex Nexans Company.
NOTE
i
