408-10415
2 of 2
Rev A
1. Disassemble the upper tooling assembly and
removal blade assembly by unscrewing the
extraction screw.
2. Insert the removal blade assembly into the
receptacle. See Figure 3.
Figure 3
3. Properly orient the side plate(s) of the upper
tooling assembly based on any adjacent receptacle
assembly(s). See Figure 2.
4. Position the upper tooling assembly over the pins
in the blade removal assembly. Lower the upper
tooling assembly until the side plates contact the pc
board. See Figure 4.
Figure 4
5. Tighten the extraction screw to remove the
receptacle assembly from the pc board. See
Figure 5.
4. MAINTENANCE AND INSPECTION
It is recommended that the tool be inspected
immediately upon its arrival to ensure that it has not
been damaged during shipment.
Figure 5
4.1. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or lint-free cloth. DO NOT
use objects that could damage the tool or any of its
components.
2. When the tool is not in use, store it in a clean, dry
area.
4.2. Periodic Inspection
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the tool or be supplied to personnel
responsible for the tool. The inspection frequency
should be based on the amount of use, working
conditions, operator training and skill, and established
company standards.
5. REPLACEMENT AND REPAIR
Order tools through your representative, or call
1-800-526-5142, or send a facsimile of your purchase
order to 717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair service, call 1-800-526-5136.
6. REVISION SUMMARY
•
Initial release of document
