©2010 Tyco Electronics Corporation, Berwyn, PA
All Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names might be trademarks of their respective owners.
Instruction Sheet
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 2
LOC B
CXP Receptacle Assembly
Removal Tool
2161060-1
408-10415
14 DEC 10 Rev A
Figure 1
1. INTRODUCTION
The CXP Receptacle Assembly Removal Tool
2161060-1 is designed to remove the connector listed
in Figure 1 from the printed circuit (pc) board.
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures and
illustrations are for reference only and are not
drawn to scale.
Read these instructions and understand them before
using the removal tool.
2. DESCRIPTION
The tool consists of a removal blade assembly, and an
upper tooling assembly. See Figure 1.
The side plates of the upper tooling assembly push on
the pc board surface while removing the receptacle.
The removal blade assembly engages the receptacle
and pulls it from the pc board. The extraction screw
draws the removal blade assembly up and pulls the
CXP receptacle assembly up and off of the pc board.
3. REMOVAL PROCEDURE
There are (4) M2 screws holding the receptacle
assembly to the pc board. These M2 screws must
be removed prior to removing the receptacle
assembly.
Be certain to remove tool assembly does not
contact any components on the pc board during
use. To prevent damage, the side plates can be
routed to clear adjacent components. See Figure 2.
Figure 2
REMOVAL TOOL
CONNECTOR DESCRIPTION
2161060-1
CXP Receptacle Assembly
NOTE
i
CAUTION
!
CAUTION
!
Extraction Screw
Upper Tooling
Assembly
Removal Blade
Assembly
Side Plates
O
R
IG
INAL
INST
RUCTIONS
