©2011 Tyco Electronics Corporation, Berwyn, PA
All Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names might be trademarks of their respective owners.
Instruction Sheet
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
www.tycoelectronics.com
1
of 4
LOC B
AMP Communications Outlet (ACO)
Single Port Kits (Cat 6)
408-8700
05 JAN 11 Rev A
1. INTRODUCTION
This instruction sheet provides termination and
installation procedures for ACO Single Port Kits. The
kits can be used in panel mount or furniture raceway
applications. Optional faceplate kits and various
adapter insert assemblies are available to meet either
application.
Dimensions on this sheet are in millimeters [with
inches in brackets]. Figures are not drawn to scale.
2. TERMINATION PROCEDURES
The 110Connect card edge connector comes pre-
installed in a single port housing. The single port
housing functions as a secure holding fixture while
terminating.
The edge connector is approved for use with 22
through 24 AWG solid wire with a maximum outside
insulation diameter of 1.6 mm [.06 in.] (100 ohm
UTP or STP).
Figure 1
Figure 2
NOTE
i
NOTE
i
NOTE
i
Cover
Single Port
Housing
110Connect
Card Edge
Connector
Unshielded Applications
Shielded Applications
Exit Left
Exit Right
