Instruction Sheet
SOLISTRAND*
Flag Terminal
408-8908
E2004 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
AMP and Tyco are trademarks. *Trademark
Other products, logos, and company names used are the property of their respective owners.
LOC B
1 of 6
TOOLING ASSISTANCE CENTER 1-800-722-1111
FAX/PRODUCT INFO 1-800-522-6752
For Regional Customer Service, visit our website at
www.tycoelectronics.com
This controlled document is subject to change.
For latest revision, call the FAX/PRODUCT INFO number.
24 SEP 04 Rev O
Crimping Dies
PROPER USE GUIDELINES
CumulativeTraumaDisorderscanresultfromtheprolongeduseofmanuallypoweredhandtools.Handtoolsareintendedforoccasionaluseandlowvolume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
–
–
–
–
–
–
Hydraulic
Hand Tool
1490749-1
Tools Using Crimping Dies for
SOLISTRAND Flag Terminals
Hydraulic Head
1490746-1
Flag Terminal Die Set (Typical)
Nest
Indenter
PRODUCT
DIES
NOMINAL WIRE
SIZE
MM
2
(CMA)
TOOLING
PRODUCT
NEST
INDENTER
MM
2
AWG
(
)
RANGE
HYDRAULIC
HEAD
HYDRAULIC
HAND TOOL
696675-1
1752682-1
6 637 10 539
696679-1
1752682-2
1752681-2
7-8
8
6.637-10.539
[13 100-20 800]
322727-[ ]
1752680-8
[13,100-20,800]
321576
1752680-7
13-15
6
10.539-16.771
[20,800-33,100]
321060
1752680-6
1752681-3
21
4
16.771-26.653
[33,100-52,600]
321064
1752680-5
34-35
2
26.653-42.411
[52,600-83,700]
1490746-1
1490749-1
321066
1752680-4
59-60
1/0
42.411-60.511
[83,700-119,500]
321584
1752680-3
1752681 1
67-70
2/0
60.551-72.259
[119,500-150,500]
327887
1752680-2
1752681-1
80-95
3/0
72.259-96.274
[150,500-190,000]
321259-[ ]
1752680-1
100-125
4/0
96.274-117.049
[190,000-231,000]
Figure 1
1. INTRODUCTION
This instruction sheet provides application
instructions, maintenance, and inspection procedures
for the dies listed in Figure 1. These dies crimp
SOLISTRAND Flag Terminals to solid or stranded
copper wire (also listed in Figure 1).
The dies are used in Hydraulic Head 1490746–1 and
Hydraulic Hand Tool 1490749–1. Refer to Figure 1.
