TYAN Transport TA26-B3892, Service Manual

Page: 42 / 76

32 Chapter 2: Setting Up
Note:
The FDD rails each have a flat side
which should be against the body of the
floppy drive when installed. There is also a
spring catch mechanism on the right hand
rail (when looking at the floppy disk drive
from the front).
3. Plug the floppy disk drive cable into the port on the back
of the floppy disk drive. Thread the cable out through the
back of the empty drive bay.
4. Slide the floppy disk drive into the drive bay until it clicks
into place and fits flush with the front panel.
5. Plug the other end of the supplied floppy disk drive cable
into the floppy disk drive controller on the motherboard.