TYAN S8230, User Manual

Page: 21 / 93

http://www.tyan.com
21
J50/J56/J51/J57/J52/J58: SATA Connector
7
GND
Connects to the Serial ATA ready
drives via the Serial ATA cable.
SATA0: J50 SATA1: J56
SATA2: J51 SATA3: J57
SATA4: J52 SATA5: J58
6
RXP
5 RXN
4 GND
3 TXN
2 TXP
1 GND
JP6: SAS Enable/Disable Jumper
Open: Normal ( Default )
Closed: Disable on-board SAS function
JP7: PCIE Switch for Slot #6 (PCI-E1) and Slot #5 (PCI-E2)
Open: Normal( Default )
NOTE: If there is no device in PCI-E2, then PCI-E1 can
support up to a x16 PCI-E signal. If there is a device in
PCI-E2 then PCIe1 can only support up to x8 PCI-E signal
Closed: Force PCI-E1 to max x8 PCI-E signal
JP8: Clear CMOS Jumper
1
Normal ( Default )
You can reset CMOS by using this jumper if you have
forgotten your system/setup password or need to clear BIOS
setting.
1. Power off system and disconnect both power connectors
from the motherboard.
2. Put jumper cap back to Pin_1 and Pin_2 (default setting).
3. Use jumper cap to close Pin_2 and Pin_3 for seconds to
Clear CMOS.
4. Reconnect power & power on system.
1
Clear CMOS