TYAN S3115, User Manual

Page: 30 / 74

http://www.tyan.com
30
We suggest using a
standard ATX 2x10 pin 120W or higher power supply,
this is of course depends on how many devices you attach. 120W is
sufficient for common system (i.e. 4 hard drives, 1 expansion card)
configuration. However, a higher wattage solution may be needed if the
system is fully loaded.
Please refer to
www.tyan.com website for further information.
Note:
YOU MUST unplug the power supply before plugging the
power cables to motherboard connectors.
2.10 - Finishing Up
Congratulations on making it this far! You’re finished setting up the hardware
aspects of your computer. Before closing up your chassis, make sure that all
cables and wires are connected properly, especially IDE cables and most
importantly, jumpers. You may have difficulty powering on your system if the
motherboard jumpers are not set correctly. In the rare circumstance that you
have experienced difficulty, you can find help by asking your vendor for
assistance. If they are not available for assistance, please find setup information
and documentation online at our website or by
calling your vendor’s support
line.