11
http://www.tyan.com
2.5 – Clear CMOS (JP1)
1
Clear CMOS
1
Default
You can reset the CMOS settings in case you have forgotten your system/setup
password or have just cleared your BIOS by using the jumpers.
•
Power off system and disconnect the AC power from the power supply.
•
Set jumper JP1 to
Clear CMOS
.
•
Power system on and wait for the screen to show this message: “CMOS
Settings Wrong, CMOS Checksum Bad”. Now your CMOS is cleared.
•
Go to BIOS Setup. Load and save setup defaults.
•
Set jumper JP1 to
Default
(OPEN) for normal operations.
2.6 – 64-bit PCI Slot Selection
(JP9) (PCI-X Slot#1 at PCI Bus 1
,
for slot located closest to the CPU)
Open (default)
the jumper to set the 64-bit slot to PCI-X mode.
Close
the jumper to set the 64-bit slot to PCI mode.
(JP11) PCI-X (PCI slot 1) Frequency Selection
Open
the jumper to set the slot to 100MHz.
Close (default)
the jumper to set the slot to 133MHz.
