http://www.tyan.com
28
Figure 2-16
Figure 2-17
Connecting the PS/2 mouse.
This board has a PS/2 mouse header built in. Simply plug the PS/2 mouse cable
into the header on the motherboard and plug your PS/2 mouse into the PS/2
port; the pins will allow you to plug the mouse in only in the correct way. If
you have any trouble locating the port, turn to the full page motherboard map
on page 12.
Warning: When plugging in your keyboard and mouse, or when plugging
anything into a serial or Com port, make sure that the power is off. Connecting
these devices and ports while the power is on is called “hot plugging,” and
may damage your system.
You are done!
Other than checking the jumper settings and cable connections and putting
the case back on, you are done. Installing a new motherboard may sound
difficult, but by following these directions, you should have had a fairly
uneventful time installing our products. If you did encounter problems, your
dealer will be able to help you, or you can consult one of our many technical
support resources (see page 7).
Chapter 2
Board Installation
