2
Windows 95 User
Power off the system and insert the Netscalibur Card.
Boot to Windows 95 and select "Do not install a driver (Windows
will not prompt you again)."
Insert the Netcalibur CD and click on the SETUP option.
Install the modem drivers, ISDN acceleration pack, ISDN
diagnostic tool, and Internet Explorer. Add TCP/IP protocol and
Dial-Up Adapter in the Network applet. Next, restart the system.
Select "Disk provided by hardware manufacturer" and browse to
the Netscalibur CD's \driver\isdn directory.
Select Netscalibur ISDN-ISA PNP and enter the correct switch
type, ISDN phone numbers, and SPID numbers.
Stop! Read the instructions carefully.
Caution
Please take note here.
Please follow this direction.
How to read the signs
Windows NT 4.0 User
In the Control Panel, run the Network applet. Remove the
Remote Access Services (RAS) before installing the Netscalibur
drivers.
In the Adapter folder, select Add and click on the Have Disk
button. Enter the \driver\isdn directory of the Netscalibur CD.
Choose an IRQ, address, and switch type. Select Multi-Point and
enter the SPID numbers with a space between the numbers.
Next, select 64000 bps and enter the ISDN phone numbers with
a space between the numbers (do not include the area code).
Add ISDN1-Netscalibur and ISDN2-Netscalibur ISDN channels
and TCP/IP protocol. Finally, restart the system.
1
2
3
4
1
2
3
4
5
6
