Crepe Maker User Manual
●
Note that the power cord should never touch any heat sources or sharp edges.
Never let the power cord dangle over the counter edge.
●
Stop using the appliance immediately if malfunctions of the unit occur. Unplug the
appliance.
●
Do not use any accessory or spare parts that have not been recommended or
designated by the manufacturer. This can pose a danger for the user or lead to
damages of the appliance or personal injury.
●
Do not lay the power cord over carpets or heat insulations. Do not cover it with any
other objects. Keep away the power cord from operating range and do not immerse it
into water.
●
Never touch the power cord, plug or the switch when your hands are wet.
●
Do not leave the unit unattended during operation.
●
Never move or reposition the unit until the unit cools down completely.
●
WARNING! Hazard via electrical current! Make sure that the voltage of local power
supply matches that of the naming plate.
●
Behind the housing, there is a copper-material equipotential terminal. The cross
section area of the connecting wire should not be lower than 1.5mm
2
.
●
The hot plate may be quite hot during operation. Keep your hands off the hot plate.
5.2 Installation and connection
ATTENTION!
The installation of the unit must be performed by a qualified technician only. Place the
device on top of a solid, even, safe and stable surface that tolerates the weight. Level it
back and forth. Then level it side to side.
Not at any time should you place the appliance on top of an inflammable surface (such
as: table cloth, carpet, etc.).
You must not locate the appliance near open fireplaces, electric ovens, electric heaters
or other heat sources.
Position the device appropriately so that the plug is always accessible.
Make sure liquids enter neither the electrical system nor the switch. Dry off the device
thoroughly!
5.3 Operating
ATTENTION!
The operation of the device may only be carried out by personnel that have been
instructed in operation of the device
Connect the wire to suitable power supply. The maximum temperature is 300
℃
. Rotate
the thermostat knob clockwise to the desired temperature scale. The unit would heat up
gradually. When the set temperature has been reached, the power supply would be cut
off automatically. When the temperature is lower than its set value, the heating function
would resume.
When a day’s work has been finished, rotate the thermostat knob anti-clockwise to its
original starting position. Shut the power supply off. If something unusual occurs, you
had better call a qualified technician for repair.
6
NO.18 - 105, HUAGANG GARDEN, ZHONGSHAN AVENUE, GUANGZHOU, CHINA
T: 86-20-38768241 | F: 86-20-38769376 |
WWW.TWOTHOUSANDCO.COM
