3.0m
1.8m
20 - 30cm
5
Should you not want to use your included frame and would like to
hang from a tree, beam or posts please follow the below guide.
To hang your Two Trees hammock you will require two fi xed
points, such as trees, beams, posts, or dyna bolts into brick walls.
Consult a qualifi ed builder if unsure.
WARNING:
Never use a free standing brick wall
to hang your hammock.
Your Two Trees hammock will require a minimum of 3 metres
between fi xing points to get the ideal shape. Rope may be needed
to attach one end of the hammock, it is recommended to use a
double piece to avoid the hammock twisting.
Hang the hammock loops at roughly the same height. When the
hammock is in use it should sit 20-30cm above the ground.
TEMPORARY INSTALLATIONS
PERMANENT INSTALLATIONS
For temporary installations, such as trees or beams, we recommend using the Two Trees hammock
hanging kit (TT501HK). For more information about our installation products please visit our website
(www.twotreeshammocks.com.au)
We recommend using the Two Trees screw
eye and hook (TT502HH). Always check with
your qualifi ed builder if unsure of safety.
For sturdy masonry walls (not air/hollow/single
brick or besser block) a 10mm dyna bolt with
a large washer and rope can be used.
Place the cord around the
pole or tree, then thread
through the fi gure eight
hook.
Thread the cord through
the clamp hook and
secure at desired length.
Repeat process for other
side of hammock. Ensure
both hooks are secure, place
hammock ends over hooks.
Read instructions before use and keep for future reference. Failure to read these instructions before use can
lead to an increased risk of injury. When installing always check with a qualifi ed builder for safety.
WARNING:
DO NOT EXCEED THE MAXIMUM LOAD OF 200KGS
HOW TO HANG YOUR HAMMOCK
HOW TO HANG YOUR HAMMOCK
1
2
3
