INSTALLATION FAULTS AND THEIR SOLUTIONS
FAULT
SOLUTION
1
The indicator light on the power
1
Check for 230 Volt at the electricity outlet
supply box is not lit
2
Check that the power supply box is connected to the
supply voltage
2
The ON / STBY indicator light on the
1
Ensure that the indicator light in the power supply
thermostat is not lit
box is on, if not see solution to the problem.
2
Check that the quick connect cables are properly
connected to the thermostat and the power supply
box
3
The damper does not respond when the
Make sure that the remote control is not switched
temperature selector knob is turned and
off.
or when the setting is changed between
1
Check that the thermostat and damper connections
1/3 and 2/3
are not interchanged. For example, thermostat # 1
is connected to the T1 entry and the damper is
connected to the +D2 and -D2 terminals
2
Check that the thermostat connections to the power
supply box are in order. (See solution to Fault 1)
3
Check that 230 Volt is supplied to the power supply
box (See Fault 1)
4
If the connections were checked and were OK as
per specification, operate the damper with the AUTO
button on the receiver. If the damper reacts, then
check the batteries.
5
Check for 12 Volt supply at the motor terminals
when the motor is intended to turn.
4
The damper does not close completely or
1
Check correct connection between the motor and the
even if it closes the motor continues to
D+ and D- power board
run
5
The damper does not reach the correct
1
Check correct connection between the motor and the
positions
D+ and D- power board
Close / Open / 1/3 - 2/3
USING THE RC 11 TO ACTIVATE THE PROPORTIONAL DAMPER
Before activating :
Make sure that the power supply box is connected
to the correct power supply. Also check that the
green indicator light on the power supply box is on.
Battery replacement and real time clock
setting
Slide down the battery cover that is located at the back
of the remote control. Insert 2 x 1.5V AAA batteries.
After placing the batteries, the real time clock on the display
will blink 0:00.
Set the actual time by pressing the +/- buttons. When the digits
show the real time, press SET for setting the time.
The real time clock can also be set using the CLOCK button
and then the same procedure using the +/- buttons and SET.
The remote control signal can be received at a distance up to 7m
Neither the remote control not the receiver should be exposed to sunlight, flourescent light or any
heat source.
Communciations between receiver and wireless handset is done via infrared signal. Therefore, the wireless
handset must have line of sight to the receiver.
