E-6
REPLACING THE LIGHT BULBS
This electric stove uses clear 120V / 40W, E12 socket base light bulbs (candelabra base, B bulb).
Access the 40W bulbs through the rear access panel (see illustration below). For convenience,
replace all bulbs at the same time if one goes out.
1. Turn the main power switch off, and then unplug the power cord from the wall outlet.
2. If the stove has been operating, let the unit cool at least 2 hours.
3. Loosen the screws holding the stove back panel to the main body of stove (see Fig.4).
4. Loosen the screw holding the spinner to the spinner motor, and then remove the spinner (Fig. 5).
5. Remove light bulbs and replace with clear 120V / 40W, E12 Socket base light bulbs (Fig. 6).
6. Place rear access panel back into position and tighten screws (Do not over tighten).
1. Loosen Phillips
head screws
2. Remove back
panel to access
light bulbs
3. Replace all
light bulbs
Spinner
Fig. 5
Fig. 4
Fig. 6
Light bulb holding spring
Pull
Pull
Emberbed
light bulbs
WARNING:
Do not exceed 40W per bulbs. Use of higher rated bulbs may result in a fire,
causing property damage or personal injury.
WARNING: Do not exceed 40W per bulbs. Use of higher rated bulbs may result in a fire,
causing property damage or personal injury.
Meijer.com
