Twin-Star International 23DM2126 Instruction Manual Download Page 11

10

NOTE: PLEASE OPERATE REMOTE TRANSMITTER AT A SLOW MEASURED PACE. PRESS THE 
REMOTE CONTROL BUTTONS  WITH AN EVEN MOTION AND GENTLE PRESSURE. REPEATEDLY 
PRESSING BUTTONS IN RAPID SUCCESSION MAY CAUSE THE  TRANSMITTER TO 
MALFUNCTION.

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off and 
on, the user is encouraged to try to correct the interference by one or more of the 
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions:
(1) This device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that may cause undesired 
operation.
Modifi cations not approved by the party responsible for compliance could void user’s authority to operate 
the equipment.

This Class B digital apparatus complies with Canadian ICES-003.

REPLACING THE REMOTE CONTROL BATTERY

When the remote control stops operating or its range seems reduced, it is time to replace the battery with 
new ones. Note: Batteries should be removed if the product is to be left unused for a long time.
1.  The battery compartment is located on the back end of the remote.
2.  Press and slide the battery door open and remove the old battery.
3.  Insert 2 AAA batteries (not included), checking that the + and - sides of the battery match inside the
 battery 

compartment.

4.  Replace the battery compartment door. 

DISPOSAL OF USED BATTERIES 

                              Battery may contain hazardous substances which could be endangering to 
                              enviroment and human health.

                              This symbol marked on the battery and/or packaging indicates that used battery shall
                              not be treated as municipal waste. Instead it shall be left at the appropriate collection
                              point for recycling.

                              By ensuring the used batteries are disposed of correctly, you will help preventing 
                              potential negative consequences for the environment and human health. The recycling
                              of materials will help to converse natural resources.

                              For more information about collection and recycling of used batteries, please contact
                              your local municipality, your waste disposal service or the point of sale where you
                              purchased this point.

Summary of Contents for 23DM2126
















Reviews: