IMPORTANT INSTRUCTION
SAVE THESE
INSTRUCTIONS
E-2
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. If provided,
use handles when moving this appliance. Keep
combustible materials, such as furniture, pillows,
bedding, papers, clothes and curtains at least 3 feet
(0.9 m) from the front of the heater and keep them
away from the sides and rear.
WARNING: In order to avoid overheating, do not
cover the heater. It cannot be used in a wardrobe.
3. CAUTION: Whenever the heater is left operating
and unattended, extreme caution is necessary if
children or invalids are nearby.
4. The appliance is not to be used by children or
persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or
instruction.
5. Children being supervised not to play with the
appliance.
6. Always unplug heater when not in use.
7. Do not operate any heater with a damaged cord or
plug or after the heater malfunctions, has been
dropped or damaged in any manner. Discard heater,
or return to authorized service facility for examination
and/or repair.
8. If the supply cord is damaged, it must be replaced
by the manufacture, its service agent or similarly
qualified persons in order to avoid a hazard.
9. Any repairs to this heater should be carried out
by a qualified service person.
10. Under no circumstances should this heater
be modified. Parts having to be removed for
servicing must be replaced prior to operating this
heater again.
11. Do not use outdoors.
12. This heater is not intended for use in bathrooms,
laundry areas and similar indoor locations. Never
locate heater where it may fall into a bathtub or other
water container.
13. Do not run cord under carpeting. Do not cover
cord with throw rugs, runners or similar coverings. Do
not route cord under furniture or appliances. Arrange
cord away from traffic areas and where it will not be
tripped over.
14. To disconnect heater, turn controls to the off, then
remove plug from outlet.
15. Connect to properly grounded outlets only.
16. This appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the current CSA C22.1
Canadian Electrical Code or for U.S.A. installations,
follow local codes and the National Electrical
Code, ANSI/NFPA NO.70.
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire,
electrical shock, and injury to persons including the following:
17. There is a thermostat limiter inside the heater.
When the inner temperature over heating or occurs
abnormal heating, the thermostat protective device
would cut off power supply to avoid the heater
damaged or risk of fire.
18. The heaters must not be located immediately
below a socket-outlet.
19. Do not insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
20. To prevent a possible fire, do not block air intakes
or exhaust in any manner. Do not use on soft
surfaces, like a bed, where opening may become
blocked.
21. A heater has hot and arcing or sparking parts
inside. Do not use it in areas where gasoline, paint
or flammable liquids are used or stored.
22. Use this heater only as described in the
manual. Any other use not recommended by the
manufacturer may cause fire, electric shock or
injury to persons.
23. Always plug heaters directly into a wall outlet/
receptacle. Never use with an extension cord or
relocatable power tap (outlet/ power strip).
24. See directions in Figure 1.
This heater is for use on 120 volts. The cord has a
plug as shown in figure 1. See Figure 1 for grounding
instruction. An adapter as shown at C is available for
connecting three-blade grounding type plugs to two-slot
receptacles. The green grounding plug extending from
the adapter must be connected to a permanet ground
such as a properly gounnded outlet box. The adapter
should not be used if a three-slot grounded receptacle
is available.
Figure 1
GROUNDING PIN
METAL SCREW
COVER OF GROUNDED
OUTLET BOX
B
A
C
GROUNDING PIN
D
ADAPTER
GROUNDING
MEANS
