Printing errors, mistakes and technical changes reserved.
V01.NK.618_EN
© by Twin Busch Germany GmbH
23
5.
Operation (using the mobile lift with manual unlocking as an example)
1. Position the vehicle to be serviced and switch off the engine.
2. Lift the lift by moving it up and down (lift truck principle) of the swiveling handle
(Steering arm) light on.
3. Slide the lift under the vehicle. (Alternatively, you can drive onto the lift,
if it was previously drained and sits firmly on the ground).
4. Make sure that the floor meets the requirements, is level and no obstacles
located on the ground.
5. Operate the pressure release handle on the swivel handle to release the lift.
The lift must be firmly on the ground.
6. Align the lift so that the lifting points on the vehicle and the lift coincide.
7. Press and hold the lift button (under the on / off switch) until the car is raised about 10-15 cm.
8. Now stop the lifting process and make sure that the car is correctly and safely aligned.
9. Lift the vehicle only at the points approved by the manufacturer.
10. If you wish to release the lift for corrective action, press and hold the unlocking lever (release the safety catch)
while pressing the release lever
at the lift.
11. To change the height of the mounting plates, turn them.
12. After final alignment and check on firm seat, press the lift button again
(under the on / off switch) and hold it to the desired height.
13. Never let the car out of sight during the lifting and lowering process.
14. To deflate, as described above, press and hold the release lever (release the safety catch) and at the same
time press the release lever on the lift.
15. Move the swiveling handle (steering lever) up and down several times until the lift is clear of the ground
and pull out the lift under the car.
Alternatively, you may also drive away the car, but in this case the lift must still rest firmly on the ground and must
not be loosened!
Summary of Contents for TW 125 F
Page 1: ......