Operation manual VERA S15
9
Figure 2.3.1 - Connection diagram VERA S15P
2.3 Operation modes
In operation mode 1 „ACTIVE“, the internal passive crossover is switched out of the signal
path, and the separation of the loudspeakers must take place in the DSP of the amplifier. The
pin connection of the VERA S15 loudspeaker is switched to pin 2+/-.
1. Set the upper switch to “OFF”! This must never be set to “ON” when no loudspeaker is
connected to the high pass output!
2. Switch the bottom switch to ACTIVE mode.
3. Connect the amplifier to the “input” connector. Do not inadvertently connect it to the high
pass output!
WARNING
two amplifier channels / 4-wire speaker cable required
Pin
1
+/-
TOP speaker
Pin
2
+/-
VERA S15 subwoofer
The top selector switch is used to activate the high pass output. The bottom selector switch
is used to activate the passive crossover and changes the pin assignment of the connection
sockets.
2.3.1 MODE 1 - ACTIVE (BI-AMPED)
OUTPUT to
additional
speaker
INPUT
Summary of Contents for VERAS15
Page 1: ...Operation manual VERAS15...
