6
VERA S33 Operating Manual
4. Setting up the loudspeaker
The VERA S33 loudspeaker is designed for suspended and standing, vertical operation.
A variety of accessories is available from TW AUDiO to securely attach the loudspeaker,
e.g. on stands or suspended from trusses and motor lifts. Horizontal operation is not in-
tended.
To create a cable connection with an amplifier rack from TW AUDiO, proceed as follows.
The correct presets need to be selected for the cable connections.
4.1 Setup
WARNING
Ensure that the loudspeakers are securely attached to prevent personal injury and prop-
erty damage. Secure stacked loudspeakers properly so that they can be tipped by 10° in
any direction without toppling.
NOTE
TW AUDiO recommends using only the accessories specified by TW AUDiO to install
and secure the loudspeakers.
4.2 Connecting cables
NOTE
Ensure that the cable cross section is sufficiently large (at least 1.5 mm²) to avoid power
losses. TW AUDiO recommends using the loudspeaker cables available from
TW AUDiO.
When connecting the cables to the loudspeaker, ensure that the polarity (+/-) and pin as-
signment (1/2) are correct. Incorrect connection results in a significant change in the
loudspeaker sound characteristics and may damage the compression driver.
The pin connections of the VERA S33 loudspeaker can be found in section 3.2 “Wiring
diagram” on page 5.
The two speakON NL4 connectors on the back of VERA S33 can be used to link multi-
ple loudspeakers on a single amplifier output. Note that parallel connection reduces the
total impedance (
Ω
) seen by the amplifier.
The total impedance must never drop below the minimum loudspeaker impedance.
Summary of Contents for VERA S33
Page 1: ...VERA S33 Operating Manual...
