TVU One Hardware User Guide | 5
TVU One Hardware User Guide
Document part number: TVUOne UG Rev A EN 04-2019
TVU Networks® Corporation, © Copyright 2019
Battery release latches
Charging the internal battery
To charge the internal battery without removing it from the
transmitter, simply connect the provided AC power adapter
to the DC input on the unit and plug in the other end of the
adapter into an electrical outlet. The battery will then begin to
charge. Please note that the battery will charge significantly
faster (approximately 3 hrs.) when the transmitter is turned off.
Inserting SIM cards
The transmitter SIM card slots are designed to hold up to 6-Mini
SIM (2FF) cards in six embedded modems. Take the following
steps to insert a SIM card into the embedded modem slots on
the transmitter:
1.
The SIM card slots are spring loaded. Simply push in the
desired SIM card into the appropriate slot until it clicks into
place.
2.
To remove a SIM card, simple push the SIM card in until it
clicks, and it will pop back out.
TVU transmitter bag configurations
The TVU transmitter is designed to be used as a standalone
transmitter or in a bag configuration. The carrying bag comfort-
ably holds the transmitter while allowing users easy access to
the power button, connections and SIM card slots.
The touchscreen LCD interface on the transmitter can also be
used while the unit is in the bag. In addition, the mesh sections
allow for the essential ventilation of the transmitter, so it will not
overheat in the carrying bag. The transmitter carrying bag can
be worn as a back pack.
The TVU One transmitter model TM1000 V2 right-side panel
features the following input/output connections and controls.
TVU One model TM1000 v2 transmitter right-side panel
Setting up the TVU One transmitter
Transmitter connections
Complete the following steps to setup the TVU One transmitter:
1.
Connect the HDMI cable to the
HDMI In
port (PAL, NTSC,
720p or 1080i).
2.
Connect the HDMI cable to the
SDI In
port (PAL, NTSC, 720p
or 1080i).
3.
Connect the
Ethernet
input cable into the Ethernet port for
a LAN connection.
4.
To preview the TVU One screen on a monitor, connect the
standard HDMI cable to the
HDMI Out
port or connect a
monitor cable to the
DP
display port.
5.
Connect your custom DC power to the
DC Input
port.
6.
Connect the audio component (3.5 mm mini audio output
jack) into the
IFB output
port.
Detaching the internal battery from the
transmitter
The transmitter internal battery is designed to fit within the
unit, but it can also be easily removed. Complete battery power
management for the TVU One transmitter is available on the
LCD touch screen as well as on the Receiver interface.
Complete the following steps to detach the internal battery
from the transmitter:
1.
On the side of the transmitter that is opposite the LCD touch
screen, users will find two spring-loaded latches.
2.
Orient the transmitter LCD panel down and push down on
the latches to release the battery and slide it away from the
transmitter.
USB 3.0
port
USB 3.1 port
Battery release tabs
Embedded
modems (6X)
SDI input
