Package
Overview
Installation
1
2
3
4
►
Connecting
Network
Cable
①
Loosen
the
nut
from
the
main
element.
②
Run
the
network
cable (without
RJ 45
connector) through the
both elements. Then
crimp
the
cable
with
RJ 45
connector
.
③
Connect
the
cable
to
the
hermetic
connector
.
Then
tighten the
nut
and
the
main
cover
.
Warning
and
Caution
■
If the product does not work properly, please contact your dealer
or the nearest service center. Never attempt to disassemble the
camera yourself. (We shall not be responsible for any problems
caused by unauthorized repair or maintenance.)
■
Do not allow water or liquid intrusion into the water.
■
In the use of the product, you must be strict compliance with the
electrical safety regulations of the nation and region. When the
product is mounted on wall or ceiling, the device shall be firmly
fixed.
■
Do
not
use
camera
beyond
specified
voltage
range
.
■
Do not drop the camera or subject it to physical shock.
■
Avoid touching the camera lens.
■
If cleaning is necessary, please use clean cloth to wipe it gently.
If the device will not be used for a long time, please cover the lens
cap to protect the device from dirt.
■
Do not aim the camera at the sun or extra bright place.
■
Do not place the camera in extremely hot, cold (the operating
temperature shall be -30˚C~60˚C), dusty or damp locations, and
do not expose it to high electromagnetic radiation.
■
To avoid heat accumulation, good ventilation is required for
operating environment.
Quick
Start
Guide
Network
Camera
Please make sure that the wall or ceiling is strong enough to withstand
3 times the weight of the camera. Please install and use the camera in
the dry environment.
①
Install a
micro
SD
card. Remove the plastic cover (a) from the
camera and then loosen the two screws of (b). Remove (b) and then
insert a micro SD card. After that, install back (b) and (a).
Camera
Quick
start
guide
Drill Template
CD
Plastic
plug
× 4
4 tapping screws PA 4×25
■
Please read this instruction carefully before operating the unit
and keep it for further reference.
■
All the examples and pictures used here are for reference only.
■
The contents of this manual are subject to change without
notice.
2
1
3
*
1 It
is
recommended
to
install
the
security
cap
for
outdoor installation
.
*
2
DC12V
power supply
is
not
required if
a
PoE switch is
used
to
power the
camera
.
②
Attach the drill template to the place where you want to fix the
camera and then drill the screw holes and the cable hole on the wall
according to the drill template.
Insert
a
micro SD card
7
8
a
b
2
9
10
11
1
3
4
5
6
DC12V
1
7
2
8
3
9
5
11
4
10
6
Fixed
ring
Micro SD card slot
CVBS output
Ethernet connector
Power connector
Audio input
Mounting base
Reset
SD card indicator
Power indicator
Network indicator
Security C
ap