HD TVI DVR
Quick Start Guide
1
Notes
●
Please read this instruction carefully for correct use of the
product and preserve it for reference purposes.
●
All the examples and pictures used here are for reference
only.
●
There may be several technically incorrect places or
printing errors in this manual. The updates will be added
into the new version of this manual. The contents of this
manual are subject to change without notice.
●
This device should be operated only from the type of power
source indicated on the marking label. The voltage of the
power must be verified before using the same.
This series of the product supports 1 SATA hard drive. Please
make sure that the device is powered off before the installation.
The pictures of the installation are only for reference, please take
the real object as the standard.
Please check the device and the accessories after getting the
device. If there are any damages, shortages or defects, please
contact your dealer immediately.
3
HDD
Installation
2
Packing Check
The interfaces of the rear panel are for reference only.
4
Rear Panel Instruction
5
Startup
&
Shutdown
Go to “Main Menu” and then select “Shutdown” icon. This
will bring up a shutdown window. The device will shut
down by clicking “OK” button. Then disconnect the power.
► NAT Settings
①
The DVR shall be powered on and connected to the network.
②
Go to Main Menu
→
Setup
→
Network
→
Network. Refer to
Fig 1. You can obtain the IP address, Subnet Mask and Gateway
automatically. You can also manually enter them according to
the actual network situation. Please make sure the network
segment is the same as that of the network which is used.
③
Set the preferred or alternative DNS Server. Click “Apply”
to save the parameters.
④
Go to Main Menu
→
Setup
→
Network
→
NAT tab. Refer to
Fig 2.
After the wizard setup, you can see the live image. Right click
to pop up a menu toolbar. Click Main Menu button. This will
take you to see a login box. The default username is
admin
;
the default password is
123456
.
Enter username and password
and click “Login” button to go to the main menu setup.
6
Login
7
NAT
►Startup
①
Connect the monitor.
②
Connect the power.
③
The device will boot and the power indicator will display
blue.
④
A wizard window will pop up.
►Shutdown
AUDIO OUT
DC12V
USB
LAN
VGA
AUDIO IN
VIDEO IN
1
3
2
4
Internet
①
Loosen the screws to open the
cover.
②
Get the HDD ready.
⑤
Turn over the machine and secure
the HDD with the screws.
③
Put
the HDD onto the bottom of
the device.
④
Connect the power and data
cables.
⑥
Install back the cover and secure
it with the screws.
