450043001393 A0
④
Bracket adjustment. Before adjustment, preview the image of the
monitor and then loosen the fixed screws to adjust the view angle of the camera.
After that, tighten the fixed screws.
camera on a
Fixed
Screws
Pan
360°
Tilt
90°
Rotate
360°
⑤
⑥
insert a micro SD card.
Press T/W button to obtain an optimum image. Before adjustment, view
the image of the camera on a monitor.
Open the cover of the camera as shown in the following figure and then
Insert a micro
SD card
Zoom+
Zoom-
Cover
Network Connection
5
●
Access the camera through IP
-
Tool
MENU
IPC
Network Cable
Network Cable
Switch
Router
Computer
①
Make sure that the camera and the PC are well connected via LAN.
②
Find the IP-Tool from the CD and then install it in the computer. After that, run the
IP-Tool as shown below.
Device
Network
Search
Immediate
Refresh
name
name
name
IPC
IPC
IPC
unknown
unknown
unknown
192.168.226.201
192.168.1.2
192.168.1.3
80
80
80
9008
9008
9008
255.255.
255.255.
255.255.
Modify Network Parameter
Mac Address
IP Address
Modify
CE :98 :23 :75 :35 :22
192
.
168
.
226
. 201
255
.
255
.
255
. 0
192
.
168
.
226
. 1
i
Tip: Enter the administrator password, and
then modify the network parameters.
Total Device: 3
Local IP Address:192
.
168
.
1
.
4
Subnet Mask:255
.
255
.
255
.
0 Gateway: 192
.
168
.
1
.
1
DNS
：
210
.
21
.
196
.
6
Device Name Device Type
IP Address
Http Port
Data Port
Subnet
Product Model
About
Subnet Mask
Gateway
Restore IPC Default Configuration
③
Modify the IP address. The default IP address of this camera is 192.168.226.201.
Click the information of the camera listed in the above table to show the network
information on the right hand. Modify the IP address and gateway of the camera and
make sure its network address is in the same local network segment as the computer’s.
Please modify the IP address of your device according to the practical situation.
Mac Address
IP Address
Modify Network Parameter
Modify
CE :98 :23 :75 :35 :22
192
.
168
.
1
. 201
255
.
255
.
255
. 0
192
.
168
.
1
. 1
Subnet Mask
Gateway
For example, the IP address of your computer is 192.168.1.4. So
the IP address of the
camera shall be changed to 192.168.1.X and the gateway shall be changed to 192.168.1.1.
After modification, please enter the password of the administrator and click “Modify”
button to modify the settings.
The default password of the administrator is “
123456
”.
④
Double-click the camera listed in the IP-Tool or manually enter the IP address in the
address bar of the web browser to connect IP-CAM. Then follow directions to
download and install the plugin.
⑤
Enter the username and password in the login interface.
The default username is
admin
; the default password is
123456
.
Note
:
Only
some
models support T&W buttons. If your camera doesn’t have these two
buttons, please skip step
⑥
.
②
Route the cables and connect the relevant cables.
③
Fasten the mounting base to the wall with the screws provided.
Mounting Base
⑦
)
Install the cover back to the camera and fix it firmly with the screws. (Note
that the cover should not be installed unevenly.
